Cessna 150-152 Club

77-02-09 CESSNA : Amendment 39-2820. Applies to the following models and serial numbers of aircraft:

Model 150
Serial Numbers 15078687 thru 78733, 78735 thru 78782, 78784 thru 78789, 78791 thru 78839, 78841 thru 78848, 78850 thru 78856, 78858 thru 78865, 78867 thru 78906, 78908 thru 78921, 78923, 78926 thru 78928, 78931, 78932, 78934 thru 78938, 78940 thru 78947, 78950 thru 78955, 78958, 78960 thru 78968, 78971 thru 78973, 78976, 78977, 78978, 78980, 78981, 78984 thru 78987, 78994, 78995, 78998

Model A150
Serial Numbers A1500697 thru 0706, 0709, 0711

Model 172
Serial Numbers 17267789 thru 67814, 67816 thru 67877, 67879 thru 67884, 67886 thru 67957, 67959 thru 67988, 67990 thru 68021, 68023 thru 68029, 68031 thru 68053, 68055 thru 68060, 68062 thru 68077, 68079, 68081 thru 68089, 68091 thru 68097, 68099 thru 68105, 68107, 68108, 68111 thru 68116, 68119, 68121 thru 68123, 68125 thru 68129, 68131 thru 68133, 68135 thru 68138, 68140, 68142, 68145 thru 68153, 68155 thru 68158, 68160, 68161, 68163, 68167, 68168, 68170 thru 68176, 68178 thru 68180, 68183, 68185, 68188, 68190, 68191, 68193, 68195, 68196, 68198, 68200 thru 68202, 68207, 68208, 68210, 68211, 68214 thru 68217, 68219, 68226, 68239

Model R172
Serial Numbers R1722028 thru 2091, 2093 thru 2096, 2098 thru 2102, 2105 thru 2108, 2111, 2112, 2115 thru 2117, 2119, 2120, 2123 thru 2125, 2134, 2140

Model 182
Serial Numbers 18265065 thru 65107, 65109 thru 65147, 65149 thru 65158, 65160 thru 65174, 65176 thru 65199, 65201 thru 65209, 65211, 65212, 65215 thru 65219, 65222 thru 65227, 65229, 65230, 65233 thru 65239, 65241, 65243, 65245, 65247, 65249 thru 65252, 65254

Model 206
Serial Numbers U20603454 thru 03469, 03471 thru 03473, 03475 thru 03491, 03493 thru 03497, 03501 thru 03505, 03507 thru 03513, 03515 thru 03519, 03521, 03523 thru 03527, 03529 thru 03534, 03536, 03538 thru 03540, 03542 thru 03547, 03549 thru 03553, 03557, 03561, 03562

Model 207
Serial Numbers 20700357 thru 00362, 00364 thru 00367

Compliance: Required as indicated, unless already accomplished.

A. Before the next flight of the affected airplanes, visually inspect the P/N C301002-0101 (12 volt) or C301002-0102 (24 volt) wing flap actuator for the date code stamp.

1. If the date code stamp on the actuator is OH, HH, WH, or ZH install a placard near the flap control which reads: “FLAP EXTENSION PROHIBITED” and operate the aircraft in accordance with this limitation.

2. Within 50 hours’ time in service after the effective date of this AD, replace the wing flap actuator ball nut assembly with an airworthy assembly in accordance with Cessna Service Letter SE76-25, dated December 13, 1976, or later approved revision. The placard required by Paragraph A.1. may be removed when the replacement ball nut assembly is installed.

3. If the date stamp code on the actuator is not one of those identified in Paragraph A.1., make an entry in the aircraft maintenance records indicating that this AD has been accomplished and the airplane may be returned to service.

B. Airplanes located where the inspection cannot be accomplished may be flown in accordance with FAR 21.197 to a place where the inspection may be accomplished, providing the flaps are not used for the flight.

C. Any equivalent method of compliance with this AD must be approved by the Chief, Engineering and Manufacturing Branch, FAA, Central Region.

NOTE 1. The date code stamp is steel stamped into the lower side of the actuator gear housing, adjacent to the flap motor and switch bar, is visible on the lower side of the actuator as it is installed in the aircraft. Inked stamped numbers on the motor housing are to be disregarded.

NOTE 2. The manufacturer has advised the FAA that sufficient replacement parts are available to accomplish Paragraph A.2. of this AD.

This amendment becomes effective February 3, 1977, to all persons except those to whom it was made effective earlier by air mail letters dated January 13, 1977.